Publicidad
Idiomas disponibles
Idiomas disponibles
by our customer service or by a qualified person and with a
cable of the same type.
• This appliance can be used by children aged from 8 years and
above and persons with reduced physical, sensory or mental ca-
pabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
• Children shall not play with the appliance.
• Cleaning and user maintenance shall not be made by children
without supervision.
• Do not immerse the device into water for cleaning. Please fol-
low the instructions as stipulated in the chapter "Cleaning".
Overview of the Components
1 Hook
2 Propeller
3 Motor shaft
4 Motor
5 Adjustment knob for oscillation
6 Set screw
7 Switch housing
8 Stand/gear casing connection screw
9 Nut for height adjustment
10 Cover cap
11 Stand tube
12 Screws for assembling the pedestal
13 Mounting plate
14 Pedestal
15 Operating mode switch
16 Rear protection grid
17 Fastening nut
18 Attachment ring for rear protection grid
19 Fastening screw
20 Fastening screw
21 Front protection grid
Not shown: Remote control
Unpacking the Device
1. Remove the device from its packaging.
2. Remove all of the packaging material such as foils, filling
material, cable holders and cardboard packaging.
3. Check the scope of delivery.
4. Check the appliance for any transport damage to prevent
a hazard.
NOTE:
There may still be dust or production residues on the sur-
face of the device. We recommend that you quickly wipe
off the housing with a damp cloth.
Assembly Instructions
The device must be completely assembled before initial
operation!
NOTE:
• You will need a Phillips screwdriver of medium size for
the assembly.
• Screws not included as accessory are already pre-
installed at the respective parts.
• Also observe the "Overview of the Components" on
page 3.
1. Place the parts of the pedestal together in the shape of a
cross.
2. Screw the mounting plate (13) tightly to the pedestal. To
do so, use the four Phillips-head screws.
3. Remove the nut for the height adjustment (9). Push the
covering cap (10) on to the lowest position of the upright
tube (11). Screw the height adjustment nut back on to the
upright tube (11).
4. Loosen the connection screw (8) and insert the gear cas-
ing (7) and the motor casing (4) on the stand tube. Then
tighten the connecting bolt by hand.
English
31
Publicidad
