Beamz Matrix33 Manual De Instrucciones página 5

MASTER/SLAVE OPERATION
1. Connect all fixtures with 3pin DMX cable, see
above section "DMX-512 connection".
2. Press the "MODE" button, display shows
"SET" and confirm by "ENTER". Use the "UP" or
"DOWN" button until display shows "MAAL" and
confirm by "ENTER" again.
3. You can choose between Master(MASt) or
Slave (ALon). The first unit must be activate by
Master and all following units must be activate by
Slave. Confirm your selection with "ENTER".
Now the slave units follows the master unit.
Noted: Any unit can be the "Master" or "Slave".
REMOTE CONTROL
With the IR remote, you can operate the moving head easy and you have many functions.
To control the fixture you must aim the remote at the front of the fixture and be no more than 30 feet away.
STAND BY:
To activate remote controller you have to switch the device in standby with the "STANDBY" key on the remote, the display now
shows STOP.
FULL ON:
You can then turn on the unit by pressing the "FULL ON" key, now the LED will light up. The display now show UHI.
The operation with the remote continued as follows:
GOBO Set:
No function
Color Setting:
Press "COLOR" and then press one of the number keys, select the color.
Strobe Setting:
Press "STROBE" and then press one of the number keys, select Speed.
Dimmer:
With the keys "DIMMER +" and "DIMMER -" you can adjust the light intensity.
Setting the program:
Press the "SHOW" button followed by a number buttons for wanted program.
You can now press the "SOUND NO" key to make the device sound activated.
By "SOUND OFF" button the device switches back to auto mode.
UHI setting
Press the "UP" or "Down" button you see on display "UHI" press "ENTER" use the "UP" or "Down" button until "SCN" is
displayed, press "ENTER". You can the Dim, Stb (Strobe), Pan, Panf (Pan fine), Pans (Pan speed), Tilt, Tilf (Tilt fine), Tits (Tilt
speed), Colr (Color) or Gobo change.
If you pan or tilt fixture change, the fixture always goes to this position. By default state fixture on 128 (home position). Use the
"UP" or "Down" button to adjust.
5