Beamz MHL810 Manual De Instrucciones página 6

select "YES" the projector lenses will light up right to left, or "NO" normal mode the projector lenses will light up right to left.
3. Press ENTER to confirm.
TEST - This function will run a self-test program.
1. Press the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self-test. Press MENU to exit.
FHRS - With this function you can display the running time of the unit.
1. Press the MENU button until "FHRS" is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU to exit.
UER - Use this function to display the Software version of the unit.
1. Press the either the MENU button until "UER" is displayed, press ENTER.
2. The display will show the software version.
RSET - This function will reset the unit.
1. Press the MENU button until "RSET" is displayed. Press the ENTER button and the unit will reset itself.
OFFSET SUBMENU
Menu
To enter the Offset Menu, press the ENTER button for at least 3 seconds. In this submenu you are able to adjust the home
positions of the tilt motor positions.
Tilt Offset - Adjustment of the tilt home position for any of the 2 bars.
1. Press the ENTER button for at least 3 seconds, then press the UP or DOWN buttons so that either "Til 1" or "Til 2" is
displayed, and press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and then press ENTER to confirm. Press the MENU button for
one second to exit.
OPERATION
The MHL810 can operate in three different modes. In each mode you can run the fixture as a standalone fixture or in a
master/slave configuration. This next section will detail the differences in the operating modes.
Universal DMX Control:
This function allows you to use a universal DMX-512 controller to control the chases and patterns, dimmer and strobe. A DMX
controller allows you to create unique programs tailored to your individual needs.
1. The MHL810 has 4 DMX Channel modes; 1 Channels, 6 Channels, 12 Channels or 36 Channels.
2. Use the controller's faders to control the various DMX fixture traits. This will allow you to create your own programs.
3. For longer cable runs (more than a 100 feet) use a terminator on the last fixture.
4. For help operating in DMX mode consult the manual included with your DMX controller.
Sound Active Mode:
This mode allows either single unit or several units linked together, to run to the beat of the music.
1. Press the MENU button until "SOUN" is displayed, and press ENTER.
2. Press the UP or DOWN button so that "ON" is displayed. The unit will now run to the beat of the music.
3. The sound sensitivity can be adjusted by pressing the MENU button until "SENS" is displayed, and then press ENTER. Use
the UP or DOWN buttons to adjust the sound sensitivity, 1 being the least sensitive, and 100 being the most sensitive.
Show Mode:
In this mode you can choose 0 of 12 show modes to run.
1. Press the MENU button until "SHND" is displayed, and press ENTER.
2. Press the UP or DOWN buttons until you find your desired show, and press ENTER then press and hold MENU for 3 seconds
to confirm.
6
UP
DOWN
UP
DOWN
UP
DOWN