Publicidad
Idiomas disponibles
Idiomas disponibles
1
YEAR
WARRANTY
7. COMMON PROBLEMS AND REMEDIES
Irregular Darkening Dimming
Headgear has been set unevenly and there is an uneven distance from the eyes to the filter lens.(Reset the head-
band to reduce the difference to the filter).
The filter Does Not Darken Or Flickers
1. Front cover lens is soiled or damaged(please change the cover lens);
2. Sensors are soiled/blocked or solar panel is blocked(Clean the sensor surface to make sure you are not blocking the
sensors or solar panel with your arm or other obstacle while welding);
3. Sensitivity is set too low or delay time id set too short(Adjust to required level);
4. Make sure proper shade is selected (not Grind mode).
5. Check battery and verify that they are in good condition and installed properly
6. Battery terminals and the contact surface of the filter are dirty or oxidized. (clean both)
The Filter Darkening without Arc Being Struck
Sensitivity set too high (Adjust Sensitivity to a required level).
The filter Remains Dark After Completing A Weld
Delay time set too long(Adjust Delay time to a required level).
Slow Response
Operating temperature is too low(Do not use at temperatures below-10°C or 14°F).
Welding Helmet Slips
Headgear is not properly adjusted.(Readjust the headband).
Poor Vision
1. Change the cover lens/clean filter.
2. Ensure ambient light is not too slow.
3. Ensure the shade number is correctly set
8
Publicidad
