Publicidad
Idiomas disponibles
Idiomas disponibles
Limitation of the movement range
Limit switches are located in the calibration and
adjustment facility's drive system. The limit switches
limit the movement range. If the permissible
movement range is exceeded and a limit switch is
actuated as a result, the calibration process is
cancelled. During set-up mode, the calibration and
adjustment facility can be manually moved outside
of this range. Exceeding the permissible movement
range may be caused for example by an improperly
adjusted ratchet on a torque wrench.
Motor overload protection
The motor is equipped with an overload and
temperature protection facility. If this is triggered,
the calibration process is cancelled.
Proceed as follows in this case:
Switch the calibration and adjustment facility off
and allow the motor to cool down.
Switch the calibration and adjustment facility on
again after it has cooled.
Transducer overload
During operation, the calibration and adjustment
facility constantly checks the transducer, which
serves as a reference, for overloading. The
transducer may be overloaded by a maximum of
25 % of the maximum measuring range value. The
software reports possible overloading via a warning
prior to the start of a calibration process. If
overloading occurs, the calibration process is
cancelled.
Calibration object overload
During operation, the calibration and adjustment
facility constantly checks the calibration object for
overloading. The calibration object may be
overloaded by a maximum of 20 % of the maximum
measuring range value. If overloading occurs, the
calibration process is cancelled.
Warning and instruction signs
Observe and comply with the warning and
instruction signs mounted on the device.
Make sure that none of the warning and
instruction signs mounted on the device are
covered over and that they are all clearly legible
at all times.
Immediately replace damaged warning and
instruction signs.
Safety
11
Publicidad
