Waterpik WP-160EU Manual De Instrucciones página 6

6
GETTING STARTED
Fill
ON
OFF
O
I
Eject
ON
ON
OFF
OFF
Power
ON
O O
I I
High
ON
OFF
O O
I
I
Low
20025501-FAA_WP-160EU_IM_F.indd 6
Powering the Unit
Plug the cord into an electrical outlet. If the outlet is controlled by a wall
switch, be sure it is turned on.
Preparing the Reservoir
Lift the reservoir lid, remove the reservoir, and fill with lukewarm water. Replace
the reservoir over the base and press down firmly and close the lid.
Inserting and Removing Tips
Insert tip into the center of the Water Flosser handle, pressing down firmly
until the tip clicks into place. The colored ring will be flush with the top of
ON
the handle if the tip is correctly locked into place. To remove tip from the
OFF
handle push the tip eject button on the handle.
Prime Unit (First Time Use Only)
Set pressure control dial on base to high (pressure setting No. 10), point
the handle and tip into sink. Turn unit ON (I) until water flows from the tip.
Turn unit OFF (O).
Adjusting the Pressure Setting
Turn the pressure control dial on the base of the unit to the lowest setting
(pressure setting No. 1) for first-time use. Gradually increase pressure over
time to the setting you prefer – or as instructed by your dental professional.
Recommended Technique
For best results, start with the back teeth and work toward the front teeth.
Glide tip along gumline and pause briefly between teeth. Continue until you
have cleaned the inside and outside of both the upper and lower teeth.
Lean over sink. Direct the stream at a 90-degree angle to your gumline with
tip in mouth. Slightly close lips to avoid splashing, but allow water to
flow freely from mouth. Set pressure at desired setting and turn the unit ON
(I). Begin cleaning.
When Finished
Turn the unit OFF (O). Empty any liquid left in the reservoir. Unplug the unit.
NOTE: If you used mouthwash or other solution besides water, see "Using
Mouthwash and Other Solutions" section.
2/5/18 7:58 AM