Waterpik WP-160EU Manual De Instrucciones página 8

8
CLEANING AND TROUBLESHOOTING YOUR WATERPIK® WATER FLOSSER
Using Mouthwash and Other Solutions
Your Waterpik Water Flosser can be used to deliver mouthwash and
®
antibacterial solutions. After using any special solution, rinse unit to
prevent clogging by partially filling reservoir with warm water and running
unit with tip pointed into sink until unit is empty.
Cleaning
Before cleaning, unplug from the electrical outlet. Clean the product when
necessary by using a soft cloth and mild non-abrasive cleanser. The water
reservoir is removable for easy cleaning and is top rack dishwasher safe.
NOTE: Remove reservoir valve before placing reservoir in dishwasher.
Remove Replace
Removing Hard Water Deposits / General Cleaning
Hard water deposits may build up in your unit, depending on the mineral content of
your water. If left unattended, it can hinder performance.
Cleaning internal parts: add 2 tablespoons of white vinegar to a full reservoir
of warm water. Point the handle and tip into sink. Turn unit ON and run until
reservoir is empty. Rinse by repeating with a full reservoir of clean warm water.
This process should be done every 1 to 3 months to ensure optimal performance.
Leakage
If leaking due to a damaged hose, replacement hoses and handles can be
purchased from your local distributor, which can be found at
www.waterpik.com/intl.
If leakage occurs from the reservoir, ensure the valve is right side up or
contact your local distributor for a replacement valve.
20025501-FAA_WP-160EU_IM_F.indd 8 2/5/18 7:58 AM