BEARWARE 302717 Manual página 15

6.1 CO2 settings
After configuring the prices and confirming them, you can access the CO2 settings
(CO2 equivalent). You can find out this value from your energy supply company.
"SET CO2" is shown in the display. Use the "UP" and "TOTAL" buttons to set the
unit of measurement (kg/kWh or lb/kWh). Then press the "SET" button to confirm
the entry.
The first digit of CO2 setting starts flashing. Configure this using the "UP" and "TO-
TAL" buttons and repeat this procedure for the second and third digit. Confirm the
setting respectively using the "SET" button.
Then press the "SET" button again to return to the normal display.
7. Display and modes
You can change between the following modes in the first line using the "MODE"
button in normal display mode: Display of costs since the start of measurement;
power display; voltage display, current consumption of the load and CO2 mode.
The second line shows the accumulated data for cost, consumption or CO2 emis-
sions. This data can be displayed for weekly, monthly and annual accumulation by
pressing the "TOTAL" button.
8. Resetting the device
Press the "RESET" button on the front side of the device using a pointed object to
delete all settings and restart the device. Caution! Be careful not to injure yourself
with the object!
To reset the accumulated data, press and hold the "TOTAL" and "UP" buttons
simultaneously for 2 seconds. The accumulated data is reset to zero.
15
English