Descargar Imprimir esta página

Cooper Lighting Solutions Halo SBL10A50GY Instrucciones Para La Instalación página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

IL51862623
CONFIGURING AND TESTING SOLAR AREA LIGHT WITH THE REMOTE CONTROL
1. Remote comes with AAA batteries included.
2. When selecting a mode of operation for this light fixture with the included remote control, the fixture will continue to operate in the selected
mode day after day. You don't need to use the remote after configuring the light fixture to your desired settings. Only if making a change to
the settings will the remote be required.
ON – Manual Fixture on 100%
OFF – Manual Fixture Off 0%
MODES OF OPERATION CONFIGURATION
MOTION mode - (Light Blinks Once when selected on remote) - This is the factory
default mode. After sundown, the fixture will turn on to 100% light output when motion is
detected. It will remain on for 30/60/90 seconds as per the below motion sensor time-out
setting selected by the user. After the time out has elapsed and no-motion detected the
fixture will turn OFF. .
DTD mode - (Light Blinks Twice when selected on remote) - After sundown, the fixture
will turn on for 12 hours of light at 10% of the rated maximum lumen output of the fixture .
MOTION+DTD mode - (Light Blinks three times when selected on remote) - After
sundown the fixture will turn on continuously at an ambient 8% lumen output and when
motion detected the light intensity will increase to 30% rated output and remains on for
30/60/90 seconds as per the below motion sensor time out setting. After the time out
setting and no-motion detected the fixture will revert back to the ambient lumen ouput
level.
MOTION SENSOR TIME OUT CONFIGURATION
30s - Applies to Motion and Motion&D2D Mode only.
30s auto time out delay after no-motion detected fixture goes to 100% OFF
60s - Applies to Motion and Motion&D2D Mode only.
60s auto time out delay after no-motion detected fixture goes to 100% OFF
90s - Applies to Motion and Motion&D2D Mode only.
90s auto time out delay after no-motion detected fixture goes to 100% OFF
CARE AND CLEANING
To prolong the original appearance, clean the light fixture with clean water and a soft, damp cloth only.
Do not use abrasive cleaners or cleaners that contain alcohol. Do not apply paints, solvents or any other chemicals on this light fixture. They
could cause a premature deterioration of the finish and may void the warranty.
Do not spray the light fixture with a hose or power washer.
BATTERY MAINTENANCE
This fixture comes with rechargeable batteries pre-installed and fully sealed inside the fixture.
These batteries are not meant to be replaced.
4
Solar LED Dusk to Dawn & Motion Activated Area Light Instructions
ENGLISH
REMOTE CONTROL
RANGE:
Max 15ft distance with
clear line of sight to the
light fixture.
www.cooperlighting.com

Publicidad

loading

Este manual también es adecuado para:

Halo sbl15a50gyHalo sbl30a50gy