Publicidad
Idiomas disponibles
Idiomas disponibles
6. Apply detergent from the bottom to the top of the dry
surface to be cleaned.
NOTE: Wetting the surface first is not recommended as it
dilutes the detergent and reduces its cleaning ability.
7. Allow the detergent to remain on the surface for a short
time before rinsing. Do not allow the detergent to dry on
the surface.
m
CAUTION!
Damage may occur to painted surfaces if
the detergent is allowed to dry on the surface. Wash and rinse
a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
8. When finished using the pressure washer, you must first
drain and rinse the detergent tank. Run the pressure
washer until all of the soap is drained from the foamer
cannon tank.
m
CAUTION!
Failure to follow these cleaning instructions
will cause the injection system to become clogged and
inoperable.
m
IMPORTANT!
NEVER USE:
• Bleach, chlorine products, and other corrosive chemicals
• Liquids containing solvents (e.g. paint thinners,
gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage
the cleaning surface.
Shutting down
1. Turn the switch to the OFF (0) position and unplug the
power cord from the outlet.
2. Turn off the water source.
3. Hold the trigger to release water pressure.
4. Disconnect the garden hose from the water inlet on
the unit.
5. Disconnect the high-pressure hose connection on the
trigger gun handle.
6. Release the trigger and engage the gun safety lock.
m
WARNING!
Turn off the water supply and squeeze the
trigger to depressurize the unit. Failure to do so could result in
personal injury due to discharge of high-pressure water.
Taking a break
If you are taking a break of five minutes or more between
cleaning tasks:
1. Engage the gun safety lock on the back.
2. Turn the switch to the OFF (0) position.
3. Unplug the power cord from the outlet.
Using the High-Pressure
Hose Adapter Kit
These adapters are used to connect other brands of high-
pressure hoses, making them compatible with your Sun Joe
pressure washer.
1. Detach the Sun Joe
gun and the unit (Fig. 22).
Fig. 22
Trigger gun
2. Connect the female end of the brass adapter to the water
outlet located on the front of the pressure washer (Fig. 23).
3. Connect the high-pressure hose end (14mm M22
threading) to the male end of the brass adapter (Fig. 24).
Fig. 23
Fig. 24
12
high-pressure hose from your trigger
®
High pressure hose
High-
pressure
hose
®
Brass
adapter
Publicidad
