Livoo SL261 Manual De Instrucciones página 11

elsewhere for better connection.
If the RF Signal is lost and do not reconnect, the outdoor temperature and humidity level will
begin to flash after 1 hour of lost connection. If no connection was found after 2 hours only a
dotted line '- - - ' will be displayed in place of the temperature and humidity level.
To manually restart the RF registration, press and hold the "CH" button for 3 seconds. The display
unit will now search for the RF signal for 3 minutes.
Use of the device
Insert the USB plug of the cable into the dedicated slot on your computer to use your weather station.
You can also the cable USB in the slot of adapter (not supplied), then connect it to power supply. Respect
carefully the maximal loading tension mentioned on the device (5V) to not damage the product. Then
plug the DC extremity of your cable in the dedicated slot at the back of the display (figure 1, n°27). The
LCD lights up.
MAIN FUNCTIONS
1. 'SET' buttons
Press and hold 'SET' button for 3 seconds during normal mode to enter setting mode. You can setup the
time format (12 or 24h) and then the time using up and down buttons (figure 1, button 22 & 23). See
chapter 5 for more instructions.
Press briefly 'SET' button to enter alarm mode. In alarm mode, press and hold 'SET' button to enter the
setting mode of the alarm time. In the setting mode, the time blinks. You can set the hour and the minute
using 'UP' and 'DOWN' button. See chapter 6 for more instruction.
2. 'CH' button
Press this button to select the communication channel (1,2,3 or scrolling mode) used with the outdoor
sensor. You also have to setup the channel of the sensor directly on it, in the battery storage location. If
you use multiple sensor, do not use the same channel for multiple sensor.
In normal display mode, press and hold 'CH' button to search RF (see chapter outdoor sensor function).
3. 'ALERT' button
Press briefly the ALERT button to enter 'alert mode'. Alert mode allow to see the defined max & min
temperature (indoor & outdoor) and max & min humidity (indoor & outdoor) from which a warning point
will be displayed on the screen of the main unit.
Press and hold the 'ALERT button' to enter alert setting and setup the max & min temperature and
humidity.
4. SNZ/LIGHT button:
Press this button to light the screen for 10 seconds (when power is generated only through batteries).
Press this button to adjust backlight (when power is generated only through USB cable).
Press to activate the snooze function when the alarm is activated.
5. Manually Setting the Time, Date & Units
Press and hold down the "SET" button for 2 seconds. The 12/24 hour mode starts to flash. Use "UP" and
"DOWN" buttons to set the correct 12/24 hour mode.
Press "SET" button to confirm your setting. The hour starts to flash. Use "UP" or "DOWN" buttons to set the
correct hour. Proceed in the same way to set the minutes, month, date & language.
Press "SET" button to confirm your setting and to end the setting procedures.
NOTE: You will automatically exit settings mode if no buttons are pressed for 20 seconds. Enter settings
mode again at any time by pressing and holding the SET button for 2 seconds.
6. Setting the Alarm
Press 'SET' button to enter alarm mode. The programmed alarm time will be shown on the screen.
Press and hold the 'SET' button for about 2 seconds to set the alarm time. The alarm hour will begin
blinking on the screen. To adjust the alarm hour, press the "UP" or "DOWN" buttons.
www.livoo.fr