HAPIMP PH810W Manual De Instrucciones página 38

7.3.CAMERA IS READY TO USE--Switch to ON
Switch the Mode Button to"On".After turn on the camera,the
screen will display 5 seconds countdown.Then the LEDs and
screen will go out. The camera begins to operate independently
and enter standby mode.
If the wild animals enter the detection range of the motion
sensors,the camera will be activated and detect the motion trail.
If the wild animals continue to move to the detection zone of the
sensor,the camera will take photos or record video automatically.
When the wild animals leave the detection zone of the sensors,
the camera will be deactivated and turn back to standby mode.
8.TROUBLESHOOTING/ FAQ
1.Question: The red light does not flash when
the mobile phone is connected to the APP
Reason:
(1) An abnormality occurs when the mobile phone and the
camera are connected
(2) Insufficient power
Correction:
1. First check whether the battery power is sufficient. If the
battery is low, it is recommended to replace the battery first
2. The hunting camera switch needs to be toggled to the "ON"
state, and reconnect the Bluetooth and turn on the WiFi.
3. If the connection fails continuously, please contact after-
sales email.
32
English 8.TROUBLESHOOTING/ FAQ