Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 11
Attached the back panel as shown nailing straight into the raw edges.
Assure that the unit is square.
Distance from corner to corner must be equal as shown.
Unfold back panel and position as shown. Line up the
large holes in the back panel with the pilot holes in the
bottom support (I). Screw in six screws (4) as shown but
do not tighten. Align back panel with all outer edges and
nail (5) straight down into back edges as shown. Tighten
the six screws (4) now.
ameriwoodhome.com
4
(x6)
#A12210
B
5
IMPORTANT! THE BACK PANEL IS A
STRUCTURAL PART OF THIS UNIT AND MUST
BE INSTALLED PROPERLY.
(x24)
#A21110
raw surface
superficie cruda
surface crue
4
D
17
5
4
I
C
4
You
Tube
Publicidad
