Create Slow Mini Manual De Instrucciones página 10

1. After use, the main body should be wiped with a dry cloth, and any remaining juices should
be wiped with a soft cloth and water. If there is serious dirt, use the cloth with neutral
detergents to wipe them gently, and then wipe them with the cloth moistened with water.
When washing the filter, remove the silicone ring from the filter and rinse it with clean
water. In addition to using a cleaning brush, clean up the residue. Afterwards, reassemble
the filter silicone ring in the original position in time for the next use.
2. It is forbidden to use volatile oils and detergents for cleaning, which may cause discolor-
ation or deformation of the device.
3. If the device remains inactive for a long time, keep it clean and dry, and store it in a
well-ventilated and dry place.
WARNING: There must be special vigilance against possible risks of personal danger, seri-
ous injury and significant loss of property.
1. Putting hands, spoons or other hard objects into the feeding cup is prohibited so as not to
cause injury, accident or damage to the machine.
2. It is forbidden to disassemble the housing of the device to avoid damage to the motor or
any other danger.
3. It is forbidden to disassemble, hit or pierce the device. It is forbidden to put the device in
water, fire or under an environment whose temperature is higher than 60 ° C to avoid a fire.
4. This device can only be used in conjunction with parts and components such as the main
body and components provided by our company. Please do not rebuild it by yourself or use
alternative parts so as not to affect work performance or cause any accident.
5. Do not put this device in a dishwasher, microwave oven, any system or hot water above 60
° C so as not to damage the parts or affect its use.
6. In the squeezing process, remove the shells and cores from the ingredients as much as
possible and cut them into appropriate pieces. Slowly put them into the feeding cup one
by one, and do not take too much force. If the ingredients cannot be extruded smoothly,
turn the switch to the stop level, pause for 1-2 seconds, then turn it to "REV" to reverse
for 2-3 seconds, and turn the switch to "ON" after 1 -2 seconds. Then the device can work
normally.
7. In the middle of the juicing process, if you find it difficult to dismantle the juicer com-
ponents, turn the switch to "REV" to reverse it for 1-2 seconds, and it will be easier to
dismantle the device.
E NGL I SH
10
CLEANING AND MAINTENANCE
PRECAUTIONS