Create Slow Mini Manual De Instrucciones página 9

3. Mount the pressing propeller on the pressing cup.
4. Mount the filter in the press cup. Align the point of the filter with the point of the press cup
(the largest buckle with the largest slot). Insert the filter into the pressing cup.
5. Mount the feeding cup on the machine and rotate it to the correct position. Align the feed
cup with the press cup. Turn it clockwise until the buckle presses on the microswitch.
After hearing a click, it indicates that the installation is complete.
Make sure you clean your slow extraction blender well before using it.
1. Place the installed machine firmly on a level table.
2. Prepare the ingredients. Cut them into suitable pieces according to the different ingre-
dients.
3. Turn the switch to the "ON" position and the device will start to work, and then put the
ingredients into the feeding cup. When the ingredients are too large to press gently, use
the pusher plunger to push the ingredients in properly.
4. If the ingredients are blocked in the press cup, turn the switch to the "REV" position for
3-5 seconds, then turn the switch to the stop position, stop working for 1-2 seconds, and
then turn the switch to "ON" for normal work.
5. After use, remove the components from the juice and clean them in time. Please note that
you need to reinstall it on the filter after cleaning the filter silicone ring so that no parts
are missing in the next use.
INSTRUCTIONS FOR USE
9
E NGLI SH