Vitamix Venturist V1200 Manual De Instrucciones página 12

The following accessories are compatible to use with Venturist blenders. Refer to vitamix.com for more information.
• Self-Detect 48 oz. (1.4 L) Wet and Dry Containers
• Self-Detect 8 oz. Bowl (225 ml) and Blade Base*
• Self-Detect 20 oz. (0.6 L) Cup and Blade Base*
• Tamper Holder Assembly*
• Blade Scraper
T H
amper older use and care insTrucTions
Note: When properly installed, the tamper holder will not interfere
with blender operation. The tamper holder can be installed on the
left or right side of the motor base.
1. Clean the parts by hand with warm, soapy water or in the top rack
in the dishwasher before assembling.
2. Choose a side of the motor base to install the tamper holder.
3. Put the tamper holder cup onto the tamper holder base. Twist the
tamper holder cup clockwise to lock into place.
4. Lift up the blender base. Plug the tab in the tamper holder base
into the slot in the motor base. Lower the blender base back onto
the work surface or counter.
5. Make sure the blender is sitting flat and steady (no rocking side
to side) before blending. When installed properly, the inside flat
surface of the tamper holder cup will sit flush with the side of the
blender (See illustration).
6. Remove the tamper holder from the blender regularly to clean. To
remove the tamper holder cup, rotate the cup counter-clockwise.
7. To remove the base, lift up on the motor base and remove the
tamper holder base.
B s
lade craper use and care insTrucTions
IMPORTANT!
Keep hands and utensils out of container while blending to reduce the risk of severe injury to
persons or damage to the blender. A rubber scraper, spatula or blade scraper may be used,
but only when the blender is not running and after the container has been removed from the
motor base.
Do not leave foreign objects, such as spoons, forks, knives, scrapers, spatulas or the lid plug,
in the container as this will damage the blades and other components when starting the
blender and may cause injury .
1. Clean the parts by hand with warm, soapy water or in the top rack in the dishwasher before use.
2. Use the blade scraper to remove thick ingredients like jam and peanut butter from under the blades only after the
container has been removed from the motor base.
12
a
p p e n d i x
Proper installation
(flush against motor base)
1 - a
c c e S S o r i e S
or here
Tab on Tamper
Holder Base
The tab on the
tamper holder base
can be plugged into
the motor base here
Blender
Motor Base