Descargar Imprimir esta página

Infiniton SD-3M Manual De Usuario página 21

Ocultar thumbs Ver también para SD-3M:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Location
Before installing this Infiniton appliance, you must choose a location that meets the following
requirements:
1.
Rigid, dry and level surface
2. Avoid direct sunlight
3. Sufficient ventilation
4. The ambient temperature must be above 0°C
5. Keep the appliance away from any heat source (cookers, boilers, radiators, etc.).
6. Install the appliance in a clean place, where there is no accumulation of dirt. Do not obstruct the air
inlets of the product.
WARNING! Stability is important to prevent the appliance from moving. Ensure that the product is
level and stable. To ensure that the vibration and noise levels emitted by the appliance during
operation are normal, the appliance should be placed on a firm and level surface.
WARNING! Make sure the power cable is not trapped or
damaged is not trapped or damaged.
WARNING! Be sure to maintain the minimum distances from the
walls, as shown in the picture on the right.
Transport
Move the appliance with extreme care. Do not grip any protruding parts of the product. The door of the
product must not be used as a carrying handle under any circumstances. If the appliance cannot be
transported in an upright position, it can be tilted to the right less than 30°.
Risk of damage and injury! Improper handling of the appliance may cause injury.
Important! The appliance is very heavy, please never carry the appliance alone;
always do so with the help of another person.
Remove all obstacles from the transport route and the installation site:
- Open doors and remove objects on the floor.
Do not use the open door as a support point.
Remove all packing materials before using the appliance.
Before installing the product, check it for externally visible damage.
Do not install or use the appliance if it is damaged.
Do not install the appliance in a room where there is a risk of frost. At temperatures close to freezing
point, the product may not operate properly. There is a risk of damage if condensed water is allowed to
freeze in the pump and hoses.
24
English
w
w
W > 20mm
infiniton.es

Publicidad

loading