Publicidad
Idiomas disponibles
Idiomas disponibles
6. Connect the air hose bank to the main control module (Fig.4).
7. Connect the two backrest cables to the corresponding cables
from the chair base (Fig.5).
8. Run the power cable out the back of the chair at the lower
right corner.
9. Pull firmly downward on the inner upholstery flap, then secure it
to the chair base using the hook-and-loop fasteners (Fig.6).
10. Pull firmly on each side of the upholstery flap, stretching it
over each corner, then secure the sides to the chair base
using the hook-and-loop fasteners (Fig.6).
relaxtheback.com
Main control
module
Air hose bank
Fig.4
Vibration connector
Heating connector
Fig.5
Inner upholstery flap
Power cable
Fig.6
6
11. Pull downward on the outer upholstery flap, then secure it
to the back of the cross bar using the hook-and-loop
fasteners (Fig.7).
Outer upholstery flap
12. Tip the chair to the upright position.
13. Lift up the backrest cushion, remove
the protective strip from the two fabric
flaps, then smooth the two fabric flaps
downward to secure them using the
Hook-and-loop fastener
hook-and-loop fasteners (Fig.8).
14. If the chair is not level (wobbles), adjust the six levelers
on the bottom of the chair as necessary to resolve the
issue (Fig.9).
Fig.7
Power cable
Backrest cushion
Two fabric flaps
Fig.8
Fig.9
7
7
Publicidad
