Publicidad
Idiomas disponibles
Idiomas disponibles
"Ubinas" - ref. 634 13 42
1.4. Operating principle
The insert is made to fit into an existing chimney. It can
also be used as the hearth of a chimney about to be built
and is designed to receive the fire.
Heat is mainly diffused by radiation through the window
and by hot air diffusion around the body of the
appliance.
The air, collected at the bottom of the appliance,
spreads around the body, where it becomes hot with the
appliance wall radiation.
The hot air rising up goes to the room through the grille
located in the hood or to the adjacent rooms via ducts
connected to jets above the appliance's heat
exchanger.
The air leaving the heat exchanger is accelereted by the
automatic start of the fans when the hot air temperature
4
!
Figure 2 - Heating principle
SYSTEM DIRECTLY ON TO THE APPLIANCE
NEVER CONNECT THE AIR DISTRIBUTION
1 - Hot air diffusion
2 - Ambiant air
3 - Radiation
is more than 50 °C. The fans stop when the air
temperature fall down.
This appliance is designed to be used only with the
door closed.
The speed is regulated with the primary air flap situated
on the main door.
A clever secondary air inlet entry through the top of
the glass door and the hearth plate completes the
combustion of volatile components and allows the door
to remain clean.
The draught restrictor enables you to balance the
combustion rate.
Description of the unit
Technical manual "1250"
Publicidad
