Cleaning Instructions - Oster BVSTBMH23 Manual De Instrucciones

5. Use only coffee beans in this appliance.
6. The Ground Coffee Chamber and its lid must always be in place when using
this appliance.
7. Do not use the finest setting when grinding coffee for your automatic drip
coffeemaker. The finer grounds could cause the coffee basket to overflow.
8. To avoid overheating the motor, do not grind more than 2 full whole bean
hoppers or 2 full 12-cup cycles without a break. Allow the motor to cool to room
temperature at least 2 minutes between cycles.
9. If the grinder stops working after running consecutive cycles, unplug the grinder
from the wall outlet and allow it to cool for at least an hour. Then plug grinder
back in and use as needed.
10. Flavored coffee beans will gum up the burrs and leave an oily residue when
stored in the whole bean hopper for long periods of time.
11. Clean after every third use for best performance.
12. After using, open the grinder to the coarsest setting and run empty to clear the
grinding path.
NOTE: For optimum freshness of your coffee beans, do NOT store in the Bean
Hopper for extended periods of time.
Remember to always clean your Burr Mill before using it for the first time. Then, to ensure
optimal mill function and durability, clean it regularly following these simple steps:
1. Always unplug your Burr Mill after use and before cleaning.
2. Wash the Bean Hopper and Ground Coffee Chamber parts with warm soapy
water. (Never use abrasive cleansers, steel wool pads or other abrasive materials.
UNIT IS NOT DISHWASHER SAFE)
CAUTION! Never immerse the Burr Mill itself in water, in any other liquid or place
in the dishwasher.
3. Dry all pieces thoroughly.
4. Install the Bean Hopper onto the unit and turn clockwise (several rotations-will
hear clicking as unit gets tighter) until it stops with the grind size indicator on Fine.
5. Place Ground Coffee Chamber Lid back on grinder chamber and then install into
unit, tightly locking into place.
NOTE: If all Bean Hopper and Ground Coffee Chamber parts are not tightly in
place correctly, the safety switches within the machine will not allow the grinder to
work. You MUST have all parts in place to safely use the Burr Mill.

cLEAnInG InStRuctIonS

E n g li s h - 8