Ice Maker Installation; Unpacking; Location Requirements - Maxx Ice MIM50 Manual De Instrucciones

Unpacking

Use two or more people to move and install ice maker.
Failure to do so can result in back or other injury.
Remove packaging materials
IMPORTANT: Do not remove any permanent instruction labels or the data label on your ice maker.
Remove tape and glue from your ice maker before using.
 To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can
also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your
fingers. Wipe with warm water and dry.

Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape
or glue. These products can damage the surface of your ice maker.
Cleaning before use
After you remove all of the packaging materials, clean the inside of your ice maker before
cleaning" in the Cleaning and Maintenance section.

Location requirements

INSTALLATION CLEARANCES:

ICE MAKER INSTALLATION

Excessive Weight Hazard
TOP VIEW
4"
Rear of unit
1"
1"
Side Side
Front of unit
8
using it. See the "Interior
SIDE VIEW
1"
Top of unit