Cleaning Your Washing Machine Before Use; Cleaning And Special Care; Starting Your Machine; End Of Programme - Edesa LC84 Manual De Instrucciones De Uso Y Mantenimiento

Cleaning your washing
machine before
It is advisable to clean the inside of your
washing machine before using it for the
first time, in order to get rid of any lubri-
cants or water left over from testing. To do
this you should:
— Put a measure of detergent into the
COMPARTMENT of the DETER-
GENT DISPENSER.
— Select WASH PROGRAMME «2» (90º
without prewash) with the programme
selector control knob.
— Start the washing machine.
— Wait until the PROGRAMME finishes.

Cleaning and special care

(Fig. 6)
Clean the accessible filter whenever the
drainage pump is blocked by foreign
bodies.
a) Loosen the base by gently pulling on
the sides and turning downwards.
Then undo the fasteners.
If there is no side access, introduce a
small screwdriver in the three slots on
the upper part of the base, in order to
lever it and loosen the hooks.
b) Use a plate or other container under
the filter to collect the water that will
be released when it is loosened.
c) Turn the filter a quarter- or halfway
sideways towards the left. Water will
start to come out.
d) When you are finished taking the water
out of the washing machine, turn the fil-
ter around several times until you can
take it out fully.
e) Remove any objects or fluff that may be
in the filter.
f ) Replace the filter and the base in their
places.
34
ENGLISH
Important: In order to avoid burns, this
operation should not be carried out when
the wash water temperature is over 30ºC.

Starting your machine

When starting your washing machine, care-
fully follow all the steps explained below:
1.- Check that the washing machine is
plugged in and that the power is tur-
ned on.
2.- Turn on the tap or open the stopcock.
3.- Put the clothes into the DRUM.
4.- Close the LOADING DOOR properly.
5.- Put the required amount of detergent
into the DETERGENT DISPENSER.
6.- Select the PROGRAMME you require
with the PROGRAMME
control knob.
7.- Select the wash temperature with the
TEMPERATURE SELECTOR control
knob.
8.- Select the required spin speed with the
SPIN SPEED SELECTOR DIAL.
9.- Select any special functions you requi-
re by pressing the corresponding but-
tons.
10.- Press the STOP/START button. The
«ON» light will come on. The wash pro-
gramme selected will now begin.

End of programme

When the programme selector control
knob reaches the STOP POSITION, this
means that the programme has finished.
DO NOT OPEN THE DOOR OF YOUR WAS-
HING MACHINE UNTIL THE DOOR
SAFETY DEVICE IS DEACTIVATED.
Press the STOP/STAR button.
SELECTOR