SNOWJOE 24V-SS10-CT Manual Del Operador página 10

IMPORTANT! Never allow the battery pack to become fully
discharged as this will cause irreversible damage to the
battery.
6. When charging is complete, remove the battery from the
charger by pulling the push lock button and sliding the
battery backward to unlock it from the charger.
Assembly
Connecting the Poles
1. Slide the middle pole into the lower pole assembly and the
upper pole assembly. Align the screw holes (Fig. 4).
Fig. 4
Lower pole
assembly
2. Insert the joint-fixing bolts through the aligned holes in the
poles and secure the other end with the washers and the
joint-fixing knobs (Fig. 5). Twist until tight.
NOTE: You may have to carefully move the wiring inside
the tube to one side if it blocks the path of the bolt.
Fig. 5
Joint-fixing
knob
Washer
Lower pole
assembly
Upper pole
assembly
Middle pole
Upper pole
assembly
Middle pole
Bolt
Operation
m
WARNING!
Keep the area to be cleared free of stones,
toys or other foreign objects that the rotor blades might pick
up and throw. Such items could be covered by snow and are
easy to overlook, so be sure to conduct a thorough inspection
of the area before beginning work.
TOOL ONLY
BATTERY + CHARGER SOLD SEPARATELY
In order to operate this cordless snow shovel you will need
a iON+ 24V System battery and charger. See page 13 for
battery and charger options and specifications, or for more
information visit snowjoe.com.
Starting the Machine
1. Slide the battery down in the battery compartment until it
clicks to lock it into position (Fig. 6).
Fig. 6
Battery
2. To start the cordless snow shovel, push and hold the
safety lock switch on the side of the handle grip with your
thumb and then squeeze the trigger switch with your
fingers. Once the machine powers on, you can release the
safety lock switch and proceed with operation (Fig. 7).
Fig. 7
Safety lock switch
Trigger switch
10
Battery
compartment