Publicidad
Idiomas disponibles
Idiomas disponibles
3. To stop the cordless snow shovel, release the trigger
switch.
Handle Adjustment
To adjust the angle of the auxiliary handle, follow the
instructions below:
1. Stop the machine and remove the battery. Wait until the
blade comes to a completely stop.
2. Loosen the auxiliary handle by turning the handle knob
counterclockwise. Rotate the auxiliary handle to a
comfortable position (Fig. 8).
Fig. 8
Auxiliary
handle
Handle knob
3. Fix the handle by tightening the handle knob. Insert the
battery and resume working.
To adjust the position of the auxiliary handle, follow the
instructions below:
1. Stop the machine and remove the battery. Wait until the
blade comes to a complete stop.
2. Loosen handle knob slightly and adjust auxiliary handle
as needed to desired position. Retighten handle knob
securely (Fig. 9).
Fig. 9
Auxiliary
handle
Loosen the
handle knob
3. Insert the battery and resume working.
NOTE: In order to prevent the auxiliary handle from moving
around or sliding on the pole, be sure to tighten securely.
Operating Tips
• Start the cordless snow shovel. Push the shovel forward
at a comfortable rate, yet slow enough to clear the path
completely. The clearing width of the snow shovel and the
depth of snowfall should dictate your forward speed.
• Direct the snow discharge to the right or to the left by
holding the cordless snow shovel at a slight angle.
• To remove snow most efficiently, throw the snow
downwind and slightly overlap each swath.
• If you need to clear snow from a crushed rock or gravel
surface, push down on the handle to keep the scraper
blade clear of any loose material that the rotor blades
could throw.
• This cordless snow shovel cuts a path 10 in. (25.4 cm)
wide and up to 6 in. (15 cm) deep in one pass.
• When clearing deeper drifts, hold the cordless snow
shovel by the upper and lower handles and use a swinging
or sweeping motion. Remove up to 6 in.
(15 cm) of snow with each pass and repeat as many
times as needed.
• Remove the battery after using the cordless snow shovel.
Hang the shovel so it will not be misplaced or damaged.
Maintenance
To order genuine replacement parts or accessories for the
Snow Joe
24V-SS10-CT cordless snow shovel, please visit
®
snowjoe.com or contact the Snow Joe
service center at 1-866-SNOWJOE (1-866-766-9563).
Proper Care for Battery + Charger
m
WARNING!
To reduce the risk of injury, always unplug
the charger and remove the battery pack from the charger
before performing any maintenance task. Never disassemble
the battery pack or charger. Contact your Snow Joe
Sun Joe
dealer or the Snow Joe
®
service center for ALL repairs.
1. To reduce the risk of injury and damage, never immerse
your battery pack or charger in liquid or allow any liquid to
flow inside these components.
2. Clean out dust and debris from charger vents and
electrical contacts by blowing with compressed air.
3. Use only mild soap on a damp cloth to clean the battery
pack and charger, keeping away from all electrical
contacts. Certain cleaning agents and solvents are harmful
to plastics and other insulated parts. Some of these
include gasoline, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and household
detergents containing ammonia. Never use flammable
or combustible solvents around battery packs, battery
chargers or tools.
4. The iON+ 24V lithium-ion battery chargers have no
serviceable parts.
11
+ Sun Joe
customer
®
®
+
®
+ Sun Joe
customer
®
®
Publicidad
