Publicidad
Idiomas disponibles
Idiomas disponibles
than 1/8 inch (3mm) thick, place the threaded clamp nut on
the spindle so that the raised section (pilot) fits into the center
of the wheel.
• figure I - If the wheel you are installing is 1/8 inch (3mm) thick or less, place the
threaded clamp nut on the spindle so that the raised section
(pilot) is not against the wheel.
4. While depressing the spindle lock button (6), tighten the
threaded clamp nut with included wrench.
5. To remove the wheel, depress the spindle lock button and
loosen the threaded clamp nut with included wrench.
NoTe: If the wheel spins after the threaded clamp nut is
tightened, check the orientation of the threaded clamp nut. If a
thin wheel is installed with the pilot on the clamp nut against the wheel, it will spin because
the height of the pilot prevents the clamp nut from holding the wheel.
SuRfAce GRINdING WITh GRINdING WheelS
1. Allow the tool to reach full speed before touching the tool to the
work surface.
2. Apply minimum pressure to the work surface, allowing the tool
to operate at high speed. Grinding rate is greatest when the tool
operates at high speed.
3. figure j - Maintain a 20˚ to 30˚ angle between the tool and work
surface.
4. Continuously move the tool in a forward and back motion to avoid creating gouges in
the work surface.
5. Remove the tool from work surface before turning tool off. Allow the tool to stop
rotating before laying it down.
edGe GRINdING WITh GRINdING WheelS
cAuTIoN:
twist while the tool is being used to do cut-off work. To reduce the risk of serious injury,
limit the use of these wheels with a standard Type 27 guard to shallow cutting and
notching (less than 1/2 inch (13mm) in depth). The open side of the guard must be
positioned away from the operator. For deeper cutting with a Type 1 cut-off wheel, use a
closed Type 1 guard. See page 9 for more information.
1. Allow the tool to reach full speed before touching the tool to the work surface.
2. Apply minimum pressure to the work surface, allowing the tool to operate at high
speed. Grinding rate is greatest when the tool operates at high speed.
3. Position yourself so that the open-underside of the wheel is facing away from you.
4. Once a cut is begun and a notch is established in the workpiece, do not change the
angle of the cut. Changing the angle will cause the wheel to bend and may cause
wheel breakage. Edge grinding wheels are not designed to withstand side pressures
caused by bending.
5. Remove the tool from the work surface before turning the tool off. Allow the tool to
stop rotating before laying it down.
cAuTIoN:
applications because these wheels are not designed for side pressures encountered with
surface grinding. Wheel breakage and injury may result.
Wheels used for edge grinding may break or kick back if they bend or
Do not use edge grinding wheels / cutting wheels for surface grinding
11
1/4 inch WHEELS
H
Threaded Clamp Nut
Backing Flange
1/8 inch WHEELS
I
Threaded Clamp Nut
Backing Flange
J
20˚-30˚
Publicidad
