Bosch TDI 902431E Instrucciones De Uso página 20

Trouble shooting
Problem
The iron does not
heat up.
"SensorSteam"
indicator lamp (3)
flashes.
The lights inside the
temperature control
(15) flash.
The clothes tend to
stick.
Water drips out of the
soleplate together
with steam.
Steam does not come
out in horizontal
position.
Excessive dripping or
steaming.
The pump does not
work.
Smoke comes out
when connecting the
iron for the first time.
Deposits come out
through the holes in
the soleplate.
The appliance makes
a pumping sound.
If none of the above solves the problem, get in touch with an authorised technical service.
20
B O SC H
Probable cause
1. Temperature control (15) set to
minimum.
2. The "SensorSteam" system has
been activated. The iron is set to
stand-by.
1. The "SensorSteam" system has
been activated. The iron is set to
stand-by.
1. The soleplate is heating up or
cooling down to the selected
temperature.
1. The temperature is too high.
1. Temperature control (15) setting is
too low.
2. You have pressed the shot of
steam button (7) repeatedly
without waiting for 5 seconds
between each press.
1. Steam control is set to "
position.
2. The temperature is too low.
Anti-drip system is activated.
1. No proper closing of "Calc'nClean"
system.
1. The iron is not in a horizontal
position.
1. This may be caused by the
lubrication of some of the internal
parts.
1. Traces of lime scale are coming
out of the steam chamber.
1. Water is being pumped into the
steam chamber.
Solution
1. Turn to a higher position.
2. Grip the handle (1) of the iron to
re-start it.
1. Grip the handle (1) of the iron to
re-start it.
1. This is normal and lights will stop
flashing when the selected
temperature is reached.
1. Turn the temperature control (15)
down and wait until the iron has
cooled down.
1. Turn the temperature control (15)
to a higher setting and wait until
the "TempOK" lights inside the
temperature control stop flashing
and remain lit continuously.
2. Wait 5 seconds between each
press of the shot of steam button.
1. Set the steam control to "eco" or
"
"max" position.
2. Set to a higher temperature if
compatible with the fabric.
1. Actuate a few times the
"Calc'nClean" button (16).
1. Use the iron in a horizontal
position.
1. This is normal and will stop after
a few minutes.
1. Carry out a cleaning cycle (see
"Calc'nClean" section).
1. This is normal.
* Model dependent