Rebound Damper; Setting The Depression Of The Rear Shock With No Load; Setting The Rear Shock Sag - DEFYGRAVITY SHERCO 250 SEF/R 2019 Manual De Propietario

250-300 SEF/R
Adjusting the chassis (continued)

REBOUND DAMPER

1
SETTING THE DEPRESSION OF THE REAR SHOCK
WITH NO LOAD

SETTING THE REAR SHOCK SAG

96
The adjusting screw
rebound behavior. Turning the screw clockwise
increases the hydraulic force (and vice versa).
Turn the screw clockwise to the stop then go
1
back the number of clicks required.
Rebound damping
With the bike on an appropriate stand
Measure the dimension R1 between a fixed point
on the chassis and the rear axle.
With the bike setting on its wheels
Measure the dimension R2 from the same fixed
point on the chassis and the rear axle. The static
deflection is the difference between R1-R2.
Static deflection
If the static deflection is not correct, adjust the
preload of the shock (
With the rider on the motorcycle
Measure the dimension R3 between the same
fixed point on the chassis and the rear axle. The
sag is the difference between R1-R3.
Sag
If the sag is not correct, change the spring.
( p.97)
☛
determines the Shock
1
Comfort 15 clicks
Standard 13 clicks
Sport 11 clicks
30mm
p.97)
☛
95mm à 105mm