Husqvarna TS 248TXD Instalación página 2

Safety instructions
WARNING:
must be done by an authorized servicing
dealer only.
WARNING:
shocks. Do the steps in the assembly
instructions in the correct sequence. Use
tools with electrical insulation.
WARNING:
wires are not damaged. Replace damaged
wires before you install the new battery.
• Remove all metal objects from your hands and
wrists.
• Use approved antistatic clothing, including gloves
and shirt.
• Use antistatic protective shoes with steel toe-cap.
• Use approved eye protection.
Battery safety
WARNING:
instructions that follow before you use the
product.
General:
• Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock and fire and/or serious injury.
• Regularly check that the batteries are intact.
Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion
Introduction
WARNING:
safety chapter before you assemble the
product.
WARNING:
shocks. Do the steps in the assembly
instructions in the correct sequence. Use
tools with electrical insulation.
2
Installation and repairs
To prevent electrical
Make sure that the battery
Read the warning
Assembly instructions
Read and understand the
To prevent electrical
Safety
or risk of injury. Never repair or open damaged
batteries.
• A damaged battery can cause an explosion and
cause injury. If the battery has a deformation or is
damaged, do not use the product and speak to an
approved Husqvarna service agent.
• Do not dismantle, open or shred batteries.
• Do not subject batteries to mechanical shock.
• Do not expose cells or batteries to heat or fire. Avoid
storage in direct sunlight.
• Do not short circuit batteries. Do not keep batteries
in storage where they can short circuit each other or
be short circuited by other metal objects.
• Do not allow battery content to come in contact with
the skin or eyes. If contact has been made, wash
the affected area with copious amounts of water and
seek medical advice.
• Do not use any battery which is not designed for use
with the equipment.
• Do not mix cells of different manufacture, capacity,
size or type within a device.
• Keep cells or batteries out of the reach of children.
• Keep the battery clean and dry.
• Use only the battery in the application for which it
was intended.
48 V batteries:
• The Husqvarna 48 V batteries, are exclusively used
as power supply for the Husqvarna battery Riders.
To avoid injury, the battery must not be used as a
power source for other devices.
• Never use batteries or appliances that is faulty,
modified or damaged.
• Never attempt to modify or repair the appliances or
the batteries. Entrust all repairs to your authorized
servicing dealer only.
CAUTION:
product or the batteries, do the steps in
the assembly instructions in the correct
sequence.
To update the firmware of the product
Note:
In assembly step 28 it is necessary to update
the firmware of the product. Make sure that you
know the Husqvarna Identification Number (HID) of
the new spare parts before you connect the product
to the Husqvarna Service Hub (HSH). The Husqvarna
Identification Number (HID) is found on the spare part.
To prevent damage to the
2052 - 001 - 29.05.2023