Publicidad
Idiomas disponibles
Idiomas disponibles
Installation - right side
1. Install the brake pedal bracket (1). Apply liquid threadlocker to the button head screw M9 x 25 mm (3/8-
16 x 1") (2) and tighten by hand.
2. Install the rear brake master cylinder (5). Use the previously dismantled clevis pin and the
corresponding cotter pin ring for this purpose.
IMPORTANT: Make sure that the clearance of the foot brake lever and pressure rod to the brake cylinder
specified by the manufacturer is set correctly.
3. Place the original screws (4) and tighten them.
4. Apply liquid threadlocker to the screws M9 x 40 mm (3/8-16 x 1,62") (3) and use them to secure the
foot support assembly (6).
Motea GmbH · Gewerbepark Grünewald 2
58540 Meinerzhagen
6
1
2
11
5
4 4
3
3
motea.com/contact
Revision status 001
08/2023
Publicidad
