motea MOTEA30 Instrucciones De Montaje página 8

Pre-assembly - left side
1
1. Guide the short leg of the torsion spring (4) into the hole of the footpeg (1).
2. Guide the long leg of the torsion spring (4) into the hole of the left foot support bracket (14).
3. Turn the footpeg (1) to the installation position and insert the clevis pin (2) and the E-shaped clip (3).
4. Install the first small O-ring (9) on the shaft of the shift rod lever (10) and insert it through the hole of the
left foot support bracket (14). Then install the second small O-ring (9) on the shaft of the shift rod lever
(10).
5. Install the nylon washer (8) on the shaft of the shift rod lever (10).
6. Set the shift lever to an angle of approx. 70° to the shift rod lever.
7. Mount the shiftpeg (6) on the shift lever (5). Use the shiftpegcrew (7) and liquid threadlocker for this
purpose.
8. Attach the shift lever (5) to the shift rod lever (10). Use the lock washer (15) and tighten the shift lever
crew (16).
9. Attach the shifter linkage rod (13) to the shift rod lever (10). Use the button head screw M8 x 25 mm
(11) and nut (12) for this purpose.
Motea GmbH · Gewerbepark Grünewald 2
58540 Meinerzhagen
6
2
4
3
16
~ 70°
7
5
8
7 9 10
15
14
8
11
12
13
Revision status 001
motea.com/contact
08/2023