Miniland Digimonitor 2.4 Gold Manual Del Usuario página 12

ENGLISH
channel 2, 3 or 4. You won't be able to pair the camera
again with channel 1 until you have paired it in another
channel and remove the channel 1 camera.
5.2.7. DELETE CAMERA
To delete one of the cameras connected, follow the
next steps:
1. Press the MENU/Back
will pop up;
2. Press the UP key or DOWN
camera icon is highlighted then press RIGHT
enter into the sub-menu;
3. Press UP key or DOWN
camera icon then press RIGHT
the sub-menu;
7. TROUBLESHOOTING
Problem Possible Cause
No reception on Camera not turned on
the monitor
Monitor not turned on
Camera: not plugged in to the power
adapter
Monitor: The power adapter is not
plugged
Monitor out or range
Connection lost between the monitor and
a camera already linked
A wrong camera has been selected
Only black and Check whether the camera is in night
white images are vision/infrared mode
displayed
The camera The camera is not turned on
does not
Camera: the power adapter is not
transmit
plugged in
VOX mode or Standby mode are active
Interference or Other electronic devices may be
poor reception interfering with the signal
The camera and monitor may be too
far apart
The battery power may be too low
The camera or monitor may be placed
too close to many metal objects
If the Baby Unit The camera and monitor may be too
has lost its link far apart
with the Parent
The link between both units has been lost
Unit
momentarily
The link between both units has been lost Pair the camera and monitor again. See 5.2.6.
key and the menu icon
key until the
key
key to select DELETE
key enter into
4. Press RIGHT /LEFT
select the desired camera to delete and press the
key.
Note: If you only have one camera paired to the
monitor, you won't be able to remove it.
Note 2: A channel needs to be deleted before pairing
to a new camera unit.
6. MAINTENANCE
• Clean the surfaces of the camera with a soft, lint-
free cloth.
• If the unit becomes dirty, use a lightly dampened
cloth to wipe surfaces, taking care to not allow water
into any openings.
• Never use cleaning agents or solvents.
Solution
Press and hold down button (III) for 2 seconds
Press and hold down the Power button (12)
Plug in the power adapter
Plug in the power adapter
Move the monitor closer to the camera
Link the camera with the monitor again.
See 5.2.6.
Change the camera number you are watching.
See 5.2.3.
In order to view the images in colour, increase
the level of light in the room the camera is in or
check there is nothing covering the camera´s
light sensor (II).
Press and hold down button (III) for 2 seconds
Plug in the power adapter
To see the monitored area continuously,
disconnect the VOX or Standby mode on the
Monitor
Move them away from the device
Move the monitor closer to the camera
Plug in the power adapter
Move them away from the device
Move the monitor closer to the camera
Reset the units by disconnecting them from
the electrical power. Wait about 15 seconds
before reconnecting. Allow up to one minute
for the Baby Unit and the Parent Unit to
synchronize.
12
/UP /DOWN key to