Publicidad
Wiring diagrams
+V
1
2
5
3
Load
Load
0 V
ANALOG
OUTPUT#1
OUTPUT
Controls and adjustment
①
⑤
④
③
①
Button
②
Button
③
Power On/Alarm (green)
④
Output #2 LED (yellow)
⑤
Output #1 LED (yellow)
Detection diagram
Analog output
10
①
②
0
300
1000
2000
a Measuring distance
b Measuring range
c Switching distance
d Hysteresis
e Background
Range Settings
This sensor can be set up to switch its outputs when a target reaches a predetermined range.
– Mount the sensor on your equipment and remove the intended target from the sensor's operating range (leaving just the background).
– Press the
button until the
The
LED should now turn on when a target is in view.
– Remove object and ensure the yellow LED turns off and the green LED is on. Repeat, if necessary, the same procedure for the
that output for a different target range detection.
– Both PNP outputs function in light operate mode. When the target is detected and
￫
the sensor "sees" light, the outputs are on. The output is low when no target is detected.
– Default factory range setting is 3.7 m (12.1 ft)
2/4
+V
4
Load
0 V
OUTPUT#2
②
Pressing this button teaches the range for Output #2 (discrete PNP)
Pressing this button teaches the range for Output #1 (discrete PNP)
Solid green LED indicates power on, any other condition indicates a setup problem
When the yellow LED
is on, the
When the yellow LED
is on, the
3000
4000
[mm]
LED blinks once. The sensor is now ready to detect all objects in the operating field, distinguishing them from the background.
output is active (discrete PNP)
output (discrete PNP) is active
Digital output
20 mm
24
③
0
3000
[mm]
5 mm
⑤
④
4000
output, if the intention is to use
Publicidad
