Simon SM34 Manual página 6

ENGLISH
This Bluetooth communications module will allow an SM34
charger to be managed through the Simon Plug&Drive APP.
1. SECURITY WARNINGS
- The installation and maintenance of SM34 equipment
and accessories must be performed by properly trained
and qualified personnel.
- Strictly comply with the current safety standards
according to the regulations in your country.
- The installer and/or maintenance personnel must be
properly protected against the risk of accidents caused
by direct and indirect contact.
- Before manipulating the equipment, make sure that it is
not connected to a power source.
- The installation must be inspected at least once a year
by a qualified technician.
- Only use original Simon S.A.U. accessories and
replacements.
- Simon S.A.U. is not responsible for damages that may
arise from inadequate use of the equipment and
accessories, nor from manipulations that modify the
original state of the equipment, accessories or the
included protections.
2. INSTALLATION
Connect the Bluetooth communications module to the
charger connector as shown:
3. CHARGER CONFIGURATION
Once the Bluetooth communications module is installed,
the charger must be configured to enable Bluetooth
communications.
ON C&K SDA04
1
switch 2 ON - Bluetooth communication enabled
OFF - Bluetooth communication disabled
Changes to the switch must be made with the charger
powered off in order to take effect.
Once Bluetooth communications have been activated, the
configuration of the charger must be completed through
the Simon Plug&Drive app.
6
2 3 4