Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Steps
Starting at the driver side-middle of the vehicle, locate the round and rectangular openings in the inner body panel.
NOTE: Mounting holes may be covered with rubber grommet and/or sealing tape. Remove to uncover mounting
locations. Insert (2) 8mm Clip Nuts, (with the nut portion to the inside), into the rectangular opening and line up the
4
Locate the driver side middle Mounting Bracket. Line up the two holes in the Mounting Bracket with the previously
installed Nut Clips and secure with (2) 8mm Hex Bolts, (2) 8mm Lock Washers and (2) 8mm Flat Washers. (Figure 5)
5
Line up the two holes in the bottom of the Mounting Bracket with the factory holes in the pinch weld. Attach the Mounting
Bracket to the pinch weld using the included (2) 8mm x 30mm Hex Bolts, (2) 8mm Flat Washers. Insert the Hex Bolt with
the Flat Washer up, from the outside-in. Secure with (2) 8mm Flat Washers, (2) 8mm Flat Washers, and (2) 8mm Hex Nuts,
(2) 8mm Flat Washer
(2) 8mm Lock Washer
(2) 8mm Hex Nut
(2) 8mm Hex Bolt
(2) 8mm Flat Washer
6
All manuals and user guides at all-guides.com
NOTE: Actual application may vary slightly from illustrations.
threaded nut with the factory round holes. (Figure 4).
(Figure 3). Snug all hardware but do not tighten at this time.
Figure 4
Figure 5
Figure 6
Page 3 of 5
Front
Publicidad
