Tristar HD-2381 Manual De Usuario página 8

eN iNstruc tioN maNuaL
• F or additional protection, we advise you to install a residual current
device (RCD) in the electrical circuit that supplies the bathroom his
electricity. This RCD must have a rated residual operating current no
higher than 30mA. Ask your installer for advice.
• This appliance is not intended for use by person (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of appliance by a person responsible for
their safety.
• Children should be supervised to ensure that they do not play with the
appliance.
• If the supply cord is damaged, it must be replaced by manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• WARNING: Do not use this appliance near water. Do not use this appliance
near bathtubs, showers, basins or other vessels containing water.
If this appliances has fallen into the water do not under no circumstances
directly grab this appliances but first pull the plug from the socket.
• When the hairdryer is used in a bathroom, unplug it after use since
the proximity of water presents a hazard even when the hairdryer is
switched off:
• For additional protection, the installation of a residual current device
(RCD) having a rated residual operation current not exceeding 30mA
is advisable in the electrical circuit supplying the bathroom. Ask your
installer for advice.
• This hair dryer if it can be fitted on the wall then it should be fitted
away and out of reach of persons who are taking a bath or washing
themselves.
8
(*) C ompetent qualified electrician: after sales department of the producer
or importer or any person who is qualified, approved and competent to
perform this kind of repairs in order to avoid all danger. In any case you
should return the appliance to this electrician.
before the first use
• T ake the appliance and accessories out the box.
Remove the stickers, protective foil or plastic from the device.
• C lean before use the appliance with a damp cloth.
• D uring first use there could be some smoke and a burning smell.
This happens because the appliance is new. It will disappear after
a few minutes. This does not mean there is a malfunction and it will
not cause one.
use
• Unwind the power cord and insert the plug into the socket.
• Put on the desired accessory, you can choose between a concentrator
or a diffuser.
• Adjust the heat level with the heat switch.
• Adjust the blowing level with the power switch.
• By pressing the cold shot button it is possible to interrupt the heating
process so that the air can be mixed according to individual requirements.
• Switch off the dryer and remove the power cord out of the socket.
• Allow the appliance to cool down.