stayer TD355W Manual De Instrucciones página 16

■ TO ADJUST DEPTH OF CUT -DISCONNECT
TOOL FROM POWER SOURCE.
The depth of cut is preset at the factory and
it should not require further adjustment. If the
saw is disassembled or for other reason the
depth of cut needs adjustment, adjust as
below:
Raise the motor head to the top.
1.
Loosen the lock nut then adjust the
2.
depth of cut to the desired level using
the supplied 6mm hex wrench. See
Fig.1.
Retighten the lock nut.
3.
■ STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is
the same as that shown on the specification
plate of the machine and that switch is
"OFF" before connecting the tool to the
power circuit.See Fig.9.
To start the machine, first squeeze the trigger
to start the motor and allow the motor to
reach full speed, then press the carriage
lock lever to all ow the motor head to
engage the workpiece. Release the trigger
switch to stop the motor.
Fig.9
Switch On / Off
ENGLISH
13
■ REMOVING CHIPS
T h i s d r y - c u t s a w h a s a n i n t e r n a l c h i p
collector tray. See Fig.10.
When the chip tray is full, the chips must be
cleared. To do this, first shut down and
DISCONNECT TOOL FROM POWER SOURCE.
Unscrew the securing knob by turning
counter-clockwise then withdraw the tray.
Replacement is the opposite of removal.
Recently-cut chips are sharp and may be
very hot. Take care when removing the tray
to keep the chips or shavings away from
your hands or other body parts. Do not
throw hot debris where paper or other
flammable materials are located.
■ THE TRANSPORT LOCK CHAIN
For ease of transport, the Transport Lock-
down chain may be used. Simply lower the
motor head and hook the chain on the
corresponding hook on the motor head.
■ LOWER RETRACTING BLADE GUARDS
The lower retracting blade guards are a
safety device important for your protection.
Every time you use the saw, make sure that
the guards rotate freely and return quickly
and completely to their closed position.
Before each use, remove any accumulated
13
Fig.10