Publicidad
Idiomas disponibles
Idiomas disponibles
The domotic transmitter has two operating modes:
- STANDARD MODE: suitable for connection to a domotic control unit.
Commands are:
Up: Contact maintained longer than 1 second between up and common.
Down: Contact maintained longer than 1 second between down and common.
Stop: No contact between up/down and common.
Activating the tilting mode (only with Clima RX and Clima Plus RX motors): Contact
maintained longer than 1 second between up, down and common.
Note: the command transmission occurs after contact is maintained for longer
than 1 second.
- ADVANCED MODE: Suitable for direct connections to wall-mounted selectors (instable
type preferably).
Commands are:
Up: Contact between up and common.
Down: Contact between down and common.
Stop: New contact on the previously selected direction.
Activating the tilting mode (only with Clima RX and Clima Plus RX motors): Quick
sequence - no longer than 0,5 seconds - between the up and down with the common.
Note for both modes: the radio transmission of each command will be repeated
three times - within few seconds - in case of disturbed reception.
- DOMOTIC CONTROL UNIT
- UP/DOWN SELECTOR
OPERATING MODES
WIRING DIAGRAM
BLUE
BROWN
DOMOTIC
RED (COMMON)
YELLOW (UP)
GREEN (DOWN)
11
TX
Garda RX
Wave RX
Wave RX V25
Senso RX
Tronic RX
Clima RX
Clima Plus RX
Publicidad
