Publicidad
Idiomas disponibles
Idiomas disponibles
PROGRAMMING MODE
: You can check machine information or change setting on Program setup, Collect Information Data,
Diagnostic Test.
There are two methods that you can enter programming mode.
How to enter Programming mode
You can enter programming mode only for Idle
state and pause state.
- Card Type
1) Insert service card.
2) Display will show
- Coin Type
1) Dissemble upper coin box key.
2) Take out the coin drop from the coin box.
3) Turn on/off the toggle switch at the back of
the coin box.
4) Display will show
- All Types
1) Push the Hot & Cold button at the same
time.
2) Push the Warm button 3 times.
3) Push the Start button.
4) Display will show
Coin Vault
Coin Box Key
Openings close
- coin type -
NOTE
• If you turn on the power without connecting meter case for the first time, the machine display
.
• When the machine is shipped from the factory, it is set in the coin type. You can change Card/
Coin type by button. (For more information refer to SETUP mode.)
• The machine will display PUSH for OPL type
• Price setting varies by country
• Set your country from
• After EEPT, reset your country (Default country is USA)
.
.
.
Insert Card
- card type -
mode (Refer How to enter the
PROGRAMMING MODE
How to use button
You can change Washer vend price, cycle time
and Cycle parameters, etc.
Press Button
Moves to upper level or
Hot
Comes back to Idle State
Moves through modes in the
Warm
Moves through modes in the
Cold
Start
Enters the selected mode
)
21
Description
same level (+)
same level (-)
- OPL type -
Publicidad
