Haier HAHG6 Serie Instrucciones De Uso página 10

Use of hob - user instructions
This appliance must only be used for the
purpose for which it is intended, domestic
cooking, and any other use will be considered
improper and could therefore be dangerous.
The Manufacturer will not be responsible for any
damage or loss resulting from improper use.
Before using burner, be sure, grid perimeters
center the burner as below figure. If you are
using Cast Iron Grids; underneath the grid,
position of it is stated. Be sure for the exact grid
is used in correct position.
USING THE GAS BURNER
Prior to switching on the gas hob ensure that
the burner caps are correctly placed within their
position. This hob is fitted with electronic
ignition to ignite the burner.
To ignite the burners carry out the following:
• Push in and turn anticlockwise to the larger
flame symbol
pushed 5 seconds after ignition. The ignition
system will continue to generate sparks as
long as the control knob is being pressed
or in position 9 and keep
Warning: If there is no electricity on appliance to
ignite the burner a match or a lighter should be
used carrying out the out the following:
• Place a lighted match or lighter close to the
burner
• Push in and turn the knob anticlockwise to the
larger flame symbol or in position 9 and keep
pushed 5 seconds after ignition Warning: In
any case if after 5 seconds the burner has not
lit, stop operating the device and wait at least 1
min before attempting a further ignition of the
burner.
KNOBS CONTROL
Each knob controls each burner as showed in
the serigraphy. The knobs have 9 steps from
highest flame to lowest flame. Never try to
switch from ° to 1
Indicators
Burner controlled by control knob
Switched-off burner
Highest power setting and electric ignition
Lowest power setting
EN 10