The hob has an automatic shutoff feature that turns off
the entire hob if any cooking zone has been operating
continuously for 2 hours.
BRIDGE FUNCTION:
In standby mode, press the "bridge" key and the bridge indicator
will turn on, the display screen will flash, and the appliance will enter
the bridge heating preparation mode.
In the bridge heating preparation mode, press the keys "-" and "+"
within 30 seconds to directly enter different furnace head heating
positions: the default power level is "5", press "-" to lower the power
(display "1") or "+" to increasethe power (display "P").
If there is no key confirmation within 30 seconds, the induction
cooker will automatically exit the bridge heating preparation mode.
TIMER SETTING
The timer setting range is 1 to 99 minutes. When in working mode,
press the "timer" key; the corresponding burner timer light will flash,
and the timer display will flash to show "00".
Press + or - to adjust the timing time, which will be increased or
decreased in units of 1 minute if it is less than 15 minutes, in units
of 5 minutes if it is between 15 minutes and 40 minutes, in units of
10 minutes if it is between 40 minutes and 99 minutes. After the
keystroke operation stops, the timer display will flash for 5 seconds,
then turn to normal, the timing light will flash, and the timing time
countdown will start. When the timer countdown is finished, the
induction cooker will "beep" and then shut down automatically.
The timer display will read the minimum time after setting
the timer for each burner.
CAUTION
The induction system is very efficient as the heat is directly
transferred to the cooking pan hene; do not put any empty pans in
the cooking zones. Instead, put oil or liquid into the pan and start the
cooking process.
The pan should always remain in the center of the heating area while
cooking. Otherwise, it will unevenly heat the bottom of the pan, and
the food in the pan will burn. While heating oil, constantly check the
pan to prevent overheating or burning.
SAFETY AND WARNING
After the induction cooker is turned off, the fan will automatically
delay operation for 1 minute to dissipate heat.
When the center temperature of the microcrystalline plate detected
℃
by NTC is higher than 50
, the '"H" will be displayed. When the
used cookware is inconsistent or is moved away from the induction
cooker, the heating will stop, the power display will read "E," and
the timer display will show "E1". If the cookware is not placed in the
desired cooking zone within 10 seconds, it will automatically turn off.
To maximise the efficiency of CookingRAK , please use pans suitable
for induction cooking. When the voltage is too high (or too low), the
heating will stop, the power display will show E, and the timer display
will show E3 (or E2). If the voltage does not return to the average
level within 10 seconds, it will automatically turn off. In this case, the
induction cooker will beep as a warning sign and must be unplugged
immediately.