CooKing RAK-CR4AAE Manual De Instrucciones página 8

TROUBLESHOOTING
Fault Possible Causes
No main supply
No standby light
Indicator operation is
OFF (dark)
Pan too small (bottom
diameter is less than
Pan is not placed in the
center of the heating
area (the cooker can't
detect the pan)
No heating
Unsuitable material pan
With fan sound and E1
error sign flash
Cooker defective
Ambient temperature
is too high (the cooling
system is not able
to keep the cooker
in normal operating
Poor heating
conditions)
Indicator operation is
ON and flashes
Cooker defective
Action to take
through operator
or operating
personnel
Check the electrical
supply (cable plugged
in the wall socket),
check preliminary fuses
Use a suitable pan
8 cm)
Move the pan to the
center of the heating
area
Choose a pan that is
recommended for an
induction cooker
Unplug the cooker
from the electrical
supply
Ask your supplier for
repair service
Verify that there is no
hot air source nearby
the induction cooker or
sucked in by the cooker
ventilation fan. The air
inlet temperature must
be lower than 40 °C
Unplug the cooker
from the electrical
supply
Ask your supplier for
repair service
TROUBLESHOOTING
Fault Possible Causes
Heating cycle switches Air inlet or air outlet
off and on within being obstructed
minutes
Fan is active
Heating switches off Fan is defective
and on within minutes
Fan control is defective
Fan is never active
Coil overheated,
After a relatively long cooking area too hot
continuous operating
time, the heating Empty pan
switches off and on
within minutes Pan with overheated oil
Small metallic objects Pan detection tuned
(e.g., a spoon) are incorrectly
heated up within the
heating zone
Action to take
through operator
or operating
personnel
Remove objects from
the air inlet and air
outlet slots
Ask your supplier for
repair service
Switch cooker off,
remove pan and wait
until the cooking area
has cooled off
Call for repairing service