Roborock S8 Manual De Instrucciones página 12

C6-2— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C6-3— Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Purchase an additional filter and alternate if necessary.
Water Tank
C7
* Clean as required.
C7-1— Open the water tank and fill it with
clean water.
C7-2— Close the water tank and shake it
gently.
C7-3— Pour out the remaining water as
shown.
VibraRise Mop Cloth
C8
* Clean after each use and replace every 3-6 months.
C8-1— Remove the VibraRise mop cloth
from the VibraRise mop cloth mount.
Clean the VibraRise mop cloth and
air-dry it.
Note: A dirty VibraRise mop will affect the mopping
performance. Clean it before use.
Robot Sensors
C9
* Clean monthly.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C9-1— Wall Sensor
C9-2— Reactive 3D Obstacle Avoidance Sensor
C9-3— Carpet Sensor
C9-4— Cliff Sensors
Charging Contact Areas
C10
* Clean monthly.
Use a soft dry cloth to wipe the charging
contacts on the charging dock and the
robot.
Battery
The robot is equipped with a built-in high-
performance lithium-ion rechargeable battery
pack. To maintain battery performance, keep
the robot charged during normal use.
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
11
Basic Parameters
Robot
Model S80ULT
14.4V/5200mAh (TYP)
Battery
lithium-ion battery
Rated Input
20V 1.2A
Charging Time < 6 hours
Note: The serial number is on a sticker on the underside of
the robot.
Charging Dock
CDZ12RR or CDZ20RR
Model
Rated Power 28W
Rated Input
100-240V~
Rated Output 20V 1.2A
Rated Frequency 50-60Hz
14.4V/5200mAh (TYP)
Charging Battery
lithium-ion battery