Makita 9741 Manual De Instrucciones página 5

Connecting to dust collector
1
3
► 1. Dust port 2. Cover plate 3. Joint
The use of a dust collector makes sanding operations
clean and dust collection easy. To connect a dust collec-
tor, open the dust port by sliding the cover plate up and
in a clockwise direction. Attach the joint onto the dust
port. Now a dust collector can be connected to this tool.
CAUTION:
• When not using a dust collector, close the dust
port opening with the cover plate.
OPERATION
1
► 1. Grip 2. Handle
Hold the tool firmly with both hands on the handle and
the grip in front. Place the tool on the workpiece surface
and move the tool gently forward and backward while
applying slight downward pressure.
CAUTION:
• The tool should not be in contact with the work-
piece surface when you turn the tool on or off.
Damage to the tool or the workpiece surface
and injury to the operator may result.
• Apply slight downward pressure only. Excessive
pressure may decrease tool efficiency, shorten
wheel service life and possibly gouge the work-
piece surface.
MAINTENANCE
•
2
•
Replacing carbon brushes
► 1. Limit mark
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
2 time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
► 1. Screwdriver 2. Brush holder cap
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment should
be performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
5 ENGLISH
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspec-
tion or maintenance.
Never use gasoline, benzine, thinner, alcohol
or the like. Discoloration, deformation or cracks
may result.
1
1
2