Publicidad
Idiomas disponibles
Idiomas disponibles
INTRODUCTION
Thanks for purchasing this vibrating alarm clock from Riptunes!
Please read all of these instructions carefully and keep them in a
safe place for future reference.
GETTING STARTED
1. Install 3 AAA batteries (not included) into the Battery Compart-
ment. The batteries are for back-up purposes in case of a pow-
er outage and should not be used normally to run the clock.
Keep the clock plugged in! If the clock is unplugged or has no
power, the batteries will drain fast, lasting only a few days. If
the clock is running only on battery power, USB charging will
not be available.
2. Plug the power cord into a standard household outlet. "12:00"
will appear on the display, and the clock is now ready to be set.
If the display is blank, adjust the Dimmer control on the top of
the clock until the clock display is seen.
3. Connect the Bed Shaker to the shaker port on the back of the
clock.
SETTING THE TIME
1. Press the TIME button. The HOUR will flash on the
display. Press (-/+) to select the correct hour.
2. Press TIME again. The MINUTE digits will flash on the
display. Press (-/+) to select the correct minute.
3. Press TIME once again. The DAY OF WEEK will flash on
the display. Press (-/+) to select the day of week.
4. Press TIME to complete the time setup.
If desired, press the 12/24H button to toggle between a
12-hour and 24-hour clock after setting the time.
–5–
Publicidad
