Suggested Pile Height Settings - Sears KENMORE ELITE 125.81714610 Manual De Uso Y Cuidado

3. Lower the wand from upright position by
pressing on the HANDLE RELEASE pedal.
4. Select a pile height setting by pressing
the ADJUSTMENT pedal on the rear of
the PowerMate®. The pile height setting
shows on the indicator.
Height Adjustment
Indicator
5. Select a position on the handle 3-way
On/Off switch.
0 CARPET /
Slide the switch forward to
the CARPET position to turn on
suction from the canister motor
and the PowerMate® agitator.
The CARPET indicator button will
turn green, and the P owerMate ®
agitator will start to spin.
0 HARDFLOOR
Slide the switch forward to the
HARDFLOOR position to turn on
canister motor suction only. The
HARDFLOOR indicator button will
turn green, and the P owerM a te ®
agitator will not spin.
Slide the switch all the way back to turn the
vacuum cleaner off. The CARPET and
HARDFLOOR indicators will both become gray.
SUGGESTED PILE HEIGHT
SETTINGS
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the P owerMate ®
agitator turned off to prevent carpet
damage.
For best deep down cleaning, use the XLO
setting. However, you may need to raise the
height to make some jobs easier, such as
scatter rugs and some deep pile carpets,
and to prevent the vacuum cleaner from
shutting off. Suggested settings are:
HI — Shag, deep pile, super-soft, or
ultraplush carpets, and scatter rugs.
MED — Medium to deep pile.
LO — Low to medium pile.
XL0 — The preferred setting for many
carpets and also for bare floors.
NOTE: To protect bare floors, place the
3-way On/Off switch in the HARDFLOOR
position to turn off agitator rotation.
A
CAUTION
DO NOT leave the PowerMate® running
in one spot for any length of time.
Damage to carpet may occur.
A
CAUTION
Product Damage Hazard
Use care if the PowerMate® and wand is
left in the upright position as it may tip
over easily. Property damage can occur if
tipped.