Operating Instructions; Getting Started; Pile Height Selection And Setting - Sears Kenmore 116.33728 Manual Del Propietário

OPERATING INSTRUCTIONS
Release
Turn the quick
release upper
Hook
cord hook to
either side
and down to
release the
power cord.
Release the power cord plug from the
power cord and pull the cord off the quick
release upper cord hook. Check to be sure
the power cord is still locked into the locking
notch on the handle.
Note: To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug,
one blade is wider than the other.
This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the
outlet, reverse the plug. If it still does not fit,
contact a qualified technician to install the
proper outlet. Do not change the plug in any
way.
Plug the polarized power cord into a 120
Volt outlet located near the floor.
Personal Injury and Product
Damage Hazard
• DO NOT plug in if switch is in the
ON position. Personal injury or
damage could result.
• DO NOT use outlets above coun-
ters. Damage from cord to items in
surrounding area could occur.
To select a pile height setting:
Turn off cleaner. Select a pile height setting
by tilting the cleaner back until front of the
nozzle is lifted slightly off the floor.
Slide the adjustment lever to the correct
setting.
SUGGESTED PILE HEIGHT SETTINGS
You may need to raise the height to make
some jobs easier, such as on scatter rugs
and longer pile carpets. Suggested settings
are:
HIGH: shag carpet, long pile, plush, scatter
rugs.
MED: medium to long pile.
LOW: short to medium pile.
EX LOW: very low pile and bare floors.
Note: When the pile height selection is
set to EX LOW the pull forces will be
stronger at the agitator. If the push/pull
forces are to aggressive or jerky a higher
setting should be used.
Adjustme._ .Z..V,11_'_'-_ {[ L%I
Lever_
WARNING
Personal Injury Hazard
To avoid personal injury, DO NOT
place hands or feet underneath
the unit when changing height
setting.
6