Overload Protector; Check Bag Indicator; Thermal Protector - Sears KENMORE ELITE 125.81714610 Manual De Uso Y Cuidado

CHECK BAG INDICATOR
When the vacuum cleaner is running with
normal airflow, the light on the CHECK
BAG indicator is off. The light comes on
whenever the airflow becomes blocked.
If that occurs, check the disposable dust
bag, motor safety filter and other
possible clog locations shown in
REMOVING CLOGS (page 16).
To correct problem: See "Check Bag
Indicator activates" in
TROUBLESHOOTING (page 24).
NOTE: The light may come on when using
certain attachments, due to reduced airflow
through attachment.
THERMAL PROTECTOR
This vacuum cleaner has a thermal
protector which automatically trips to
protect the vacuum cleaner from
overheating. If a clog prevents the normal
flow of air to the motor, the thermal
protector turns the motor off
automatically. This allows the motor to
cool in order to prevent possible damage
to the vacuum cleaner.
To correct problem: Turn off and unplug
vacuum cleaner to allow the vacuum
cleaner to cool and the thermal protector
to reset. Check for and remove clogs, if
necessary. Also check and replace any
clogged filters. Wait approximately fifty
(50) minutes and plug the vacuum cleaner
in and turn back on to see if the motor
protector has reset.
If the canister motor does not resume
operation after the reset procedure
described above, have the unit serviced
by a Sears or other qualified service dealer.
AWARNING
Personal Injury Hazard
Always turn off and unplug the vacuum
cleaner before cleaning the agitator area
as agitator may suddenly restart. Failure
to do so can result in personal injury.
OVERLOAD PROTECTOR
The PowerMate® has built-in protection
against motor and belt damage should the
agitator jam. If the agitator slows down or
stops, the overload protector shuts off the
PowerMate® . The canister motor will continue
to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press OVERLOAD PROTECTOR RESET
button.
If the PowerMate motor still does not run
after reset, have the unit serviced by a
Sears or other qualified service dealer.
ELECTRONIC SUCTION CONTROL
The electronic suction control allows you to
change the power of the vacuum cleaner
suction motor.
Increase suction
for upholsteries
and carpets.
Decrease suction
for draperies and
lightweight rugs.
SUCTION
CONTROL
Increase
Suction
Decrease
Suction
-15 -