Sauder Briarbrook Serie Instrucciones De Montaje página 11

Step 6
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper diagram below. Be
prepared, the parts are greasy.
å
Fasten the EXTENSION RAILS (1) to the ENDS (C and D). Use sixteen BLACK 1/2" FLAT HEAD SCREWS (26).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge
of the EXTENSION RAIL in to find the other holes that line up with the holes in the ENDS. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
430070
2
Push the black lever and pull the
SLIDE from the RAIL.
1
1
C
www.sauder.com/service
Use these holes.
BLACK 1/2" FLAT HEAD SCREW
(16 used in this step)
1
1
D
1
26
Open end
Open end
Page 11