Sauder Briarbrook Serie Instrucciones De Montaje página 27

Step 22
å
Carefully stand your unit upright. Pull the lower wing of the INTERLOCK MECHANISM (6) forward until it clicks into
place as shown in Diagram 1.
å
To insert the lower drawer into your unit, line up the EXTENSION SLIDES on the drawers with the EXTENSION RAILS
on the unit and push the drawer into the unit until the drawer it is fully inserted.
å
NOTE: The lower DRAWER ACTUATOR will be near the top of the LEFT DRAWER SIDE as shown in Diagram 2.
å
Pull the upper wing of the INTERLOCK MECHANISM (6) forward until it clicks into place as shown in Diagram 3.
å
NOTE: Be sure the bolt on the LOCK is in the down position as shown in the large view. If it is not, insert a KEY and turn.
until the lock bolt is down.
å
Insert the upper drawer by lining up the EXTENSION SLIDES on the upper drawer with the EXTENSION RAILS on the
unit as shown in Diagram 3. Push the drawer in until it is fully inserted. To lock the upper drawer insert the KEY and turn.
1
Pull the lower
wing forward until
it clicks into place.
Pull the upper
wing forward until
it clicks into place.
430070
The Lower Drawer
ACTUATOR must
be here.
www.sauder.com/service
2
The lock bolt should be
3
in the down position.
Page 27