Sauder Briarbrook Serie Instrucciones De Montaje página 17

Step 11
å
Carefully turn your unit onto its back.
å
NOTE: You should start each SCREW a few turns before completely
tightening any of them.
å
Fasten the END FRAMES (P and Q) to the ENDS (B and C). Tighten eight
1/2" HEX HEAD SCREWS (24) using the L-WRENCH (16).
å
NOTE: Pay close attention to the location of the holes in the top edges of
the END FRAMES (P and Q).
å
Fasten the BOTTOM (S) to the END FRAMES (P and Q). Tighten four
1/2" HEX HEAD SCREWS (24) using the L-WRENCH (16).
å
Fasten the END FRAMES (P and Q) to the BRACES (R). Tighten four 1/2"
HEX HEAD SCREWS (24) using the L-WRENCH (16).
The holes are
closer to the
back edge.
P
B
1/2" HEX HEAD SCREW
(16 used in this step)
430074
R
R
16
24
www.sauder.com/service
C
S
Q
Page 17